Filter
Top Products
2.0 Quick Start
1. Install the CD into the CD drive of the computer
and install the SensorEval software (see Section
4.0).
2. Hookup the USB cable between the PC or
notebook computer and the LM95235EVAL
board as shown in Quick Start Diagram (See
Section 2.1).
3. Run the SensorEval software clicking the icon
on the desktop. The first screen after the
installation will look like this:
If not, select “Another Device”. The next screen
should look like this:
Select LM95235 and click on Open button.
4. The next screen (first screen after the first run of
the program) will look like this:
Select the LM95235 Evaluation Board.
Click OK.
5. The next screen will look like this:
Make sure that “4C” is selected in the upper left
box labeled “I2C Addr”. Select “All Regs” in the
“Read Cont” box to read all of the registers,
including the temperature registers continuously.
© Copyright 2006 National Semiconductor Corporation 5 www.national.com