Filter
Top Products
© National Instruments Corporation 2-1 FBUS-HSE/H1 LD User Manual
2
Hardware Installation and
Configuration
Installing the FBUS-HSE/H1 LD
The FBUS-HSE/H1 LD has a simple rail clip for reliable mounting onto a
standard 35 mm DIN rail. Complete the following steps to mount the
FBUS-HSE/H1 LD on a DIN rail.
1. Use a flathead screwdriver to open the DIN rail clip to the unlocked
position, as shown in Figure 2-1.
Figure 2-1. DIN Rail Clip
2. Hook the lip on the rear of the FBUS-HSE/H1 LD onto the top of a
35 mm DIN rail and press the FBUS-HSE/H1 LD down onto the DIN
rail, as shown in Figure 2-2.
Rail Clip Locked Rail Clip Unlocked