Filter
Top Products
Contents
© National Instruments Corporation ix PXI-846x and NI-CAN for Windows NT
Appendix G
Specifications
Appendix H
Technical Support Resources
Glossary
Index
Figures
Figure 2-1. Add/Remove Programs Properties Dialog Box.....................................2-2
Figure 2-2. Installing the PXI Hardware..................................................................2-4
Figure 2-3. PXI-8461 That Is Working Properly.....................................................2-5
Figure 2-4. NI-CAN Hardware Settings Dialog Box...............................................2-6
Figure 3-1. NI-CAN Diagnostic Utility after Testing..............................................3-1
Figure A-1. Add/Remove Programs Properties Dialog Box.....................................A-2
Figure B-1. Pinout for 9-Pin D-Sub Connector........................................................B-1
Figure B-2. PXI-8460 Parts Locator Diagram..........................................................B-2
Figure B-3. Power Source Jumpers ..........................................................................B-3
Figure B-4. Termination Resistor Placement for Low-Speed CAN.........................B-5
Figure B-5. Location of Termination Resistors on a PXI-8460 ...............................B-7
Figure B-6. Preparing Lead Wires of Replacement Resistors..................................B-7
Figure B-7. Cabling Example...................................................................................B-8
Figure C-1. Pinout for 9-Pin D-Sub Connector........................................................C-1
Figure C-2. Pinout for 5-Pin Combicon-Style Pluggable Screw Terminal ..............C-2
Figure C-3. PXI-8461 Part Locator Diagram ...........................................................C-3
Figure C-4. Power Source Jumpers ..........................................................................C-4
Figure C-5. Termination Resistor Placement ...........................................................C-6
Figure C-6. Cabling Example...................................................................................C-7