Filter
Top Products
Chapter 2 System Setup
© National Instruments Corporation 2-3 TPC-2012 User Manual
Caution Be sure system power is off before plugging in or pulling out the CompactFlash
card.
2. Install a CompactFlash card containing Windows CE, embedded
Windows XP, or another operating system.
3. Connect the power connector to 24 VDC power lines. Be sure to
connect the positive, negative, and ground lines as shown in
Figure 2-1. The power lines can be from either a power adapter or
in-house power source.
Figure 2-1. Power Connector
4. Connect the power connector to the power receptor on the TPC-2012.
The power receptor pin assignment is shown in Figure 2-2.
Figure 2-2. Power Receptor and Pin Assignment
5. Switch on the power switch to power on the system.
Touchscreen Calibration
The TPC-2012 touchscreen should be correctly calibrated and ready to use
when you power on the system. However, if the calibration is not correct or
you want to choose custom calibration options, refer to Appendix F,
Touchscreen Configuration.
+
–
GND
GND
–
+