Filter
Top Products
Chapter 2 System Setup
TPC-2012 User Manual 2-4 ni.com
Panel Mounting
Follow these steps to mount the TPC-2012 in a panel:
1. Be sure the adhesive waterproof gasket on the front bezel is in position.
2. Install the TPC-2012 in the panel opening. (Refer to Appendix A,
Specifications, for cutout dimensions.)
3. Hook the clamps included in the accessory pack to the holes around the
four sides of the bezel.
4. Insert the screws included in the accessory pack into the clamps. To
fasten the TPC-2012 to the panel, tighten the screws so they push
against the mounting panel.
Note The mounting panel thickness should be less than 6 mm (0.236 in.).