Filter
Top Products
14 SuperScript Color Laser Network Guide
Using BOOTPL32
First follow these directions to set up TCP/IP in Windows
95/98 and Windows NT 4.0:
Installing the TCP/IP Protocol
1. In Windows, open the Network control panel.
2. If TCP/IP Protocol is not installed, install it in the
following step (in Windows 95).
a. Select Configuration Tab in the Network control
panel and click Add button.
b. When Select Network Component Type dialog box is
displayed, select Protocol and click Add button.
c. When Select Network Protocol dialog box is
displayed, select Microsoft and TCP/IP and click OK
button.
d. Then, TCP/IP Protocol is installed.
e. Restart. The new protocol and service will not be
available until system is restarted.
Assigning the IP Address
Use BOOTPL32 to set the IP address and other TCP/IP
parameters manually. You can also use ARP/ping commands
if you prefer.
1. Insert the SuperScript Color Laser CD.
2. Launch BOOTPL32
In Windows access the CD ROM drive and launch
BOOTPL32 from the bootp directory
or Type E:\BOOTP\BOOTPL32.EXE from the Start>Run
dialog box.