Filter
Top Products
1-5
3
Quick Start
Figure A.1
To attach the FE monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync FE Macintosh cable adapter (not included)
to the monitor connector on the Macintosh (Figure B.1). Attach the 15-pin
mini D-SUB end of the captive signal cable to the MultiSync FE Macintosh
cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync FE Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.
4. For download information on the Windows
®
95/98/Me/2000/XP INF file
for your MultiSync monitor, refer to the References section of this User’s
Manual.
5. Connect one end of the power cord to the MultiSync FE monitor and the other
end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
Figure B.1
Captive Signal Cable
Captive Signal Cable
15-pin
mini
D-SUB
Mac Adapter
(Not Included)