Filter
Top Products
Upgrading Your System 4-11
Replacing the SEPP Version
1. Power off the system and remove the left side panel as described earlier in
this chapter.
2. Pull the processor latches, Item A in Figure "Removing a Processor" below,
out away from the edges of the SEPP to free them from the Universal
Retention Module (URM).
3. Lift the SEP processor upward, out of the URM and place it on a grounded,
static-free surface or conductive foam pad.
Removing a Processor
4. Remove the attachment clip, Item A in Figure "Processor Heat Sink
Assembly" below, that secures the heat sink to the old processor.
5. Remove the heat sink, Item C in Figure "Processor Heat Sink Assembly"
from the front of the old processor, Item B in Figure "Processor Heat Sink
Assembly" below.
6. Put the old processor in a piece of conductive foam and store in an antistatic
package.
Processor Heat Sink Assembly