NEC MT 1020 Projector User Manual


 
3. Use the MultiCable that's supplied to connect your PC or Macintosh computer to the
LCD projector. For a PC, use the smaller 15-pin connector on the cable to connect to
your computer's video port; use the larger 15-pin connector on the cable to connect
to the projector's RGB 1 input. For Macintosh, use the larger 15-pin connector on the
cable to connect to your computer's video port; use the smaller 15-pin connector on
the cable to connect to the projector's RGB 2 input. (You can also use your own
video cable if you wish. For a PC cable, use the smaller 15-pin connector RGB 2 on
the projector. For a Macintosh cable, use the larger 15-pin connector RGB 1 on the
projector.)
4. Turn on the LCD projector and the computer.
5. If the projector goes blank after a period of inactivity, it may be caused by a screen
saver installed on the computer you've connected to the projector.
NOTE: Refer to your computer's owner's manual for more information about your
computer's video output requirements and any special identification or configuring your
projector's image and monitor may require.
INSTALLATION
37
38
Connecting Your PC Or Macintosh Computer
Connecting your PC or Macintosh computer to your MultiSync MT820 (SVGA)/
MT1020 (XGA) LCD Projector will enable you to project your computer's screen
image for an impressive presentation. All of these following display standards are
supported:
* indicates that this resolution is supported by MT1020 only.
To connect to a PC, Macintosh or computer equipped with an XGA/SVGA/VGA
adapter or compatible graphics adapter, simply:
1. Turn off the power to your LCD projector and computer.
2. If your PC does not support XGA/SVGA/VGA you will need to install an XGA/
SVGA/VGA graphics board. Consult your computer's owner's manual for your
XGA/SVGA/VGA configuration. If you need to install a new board, see the manual
that comes with your new graphics board for installation instructions.
VGA 640ן480 for graphics VGA 640ן400 for graphics
VGA 640ן350 for graphics VGA 720ן400 for text
VGA 720ן350 for text SVGA 800ן600
XGA 1024ן768* Macintosh at 1024ן768*
Macintosh at 640ן480 Macintosh at 832ן624