NEC MT 1020 Projector User Manual


 
This section introduces you to your new MultiSync MT1020
(XGA)/MT820 (SVGA) LCD Projector, provides a list of materials
that comes with your projector and describes the features and con-
trols.
Congratulations On Your Purchase Of The MultiSync
MT1020/MT820 LCD Projector
The MultiSync MT1020/MT820 is one of the very best LCD projec-
tors available today. The multiple LCD panels enable you to project
precise images up to 300 inches across (measured diagonally) from
your PC or Macintosh computer (desktop or notebook), VCR, docu-
ment camera, or even a laser disc player.
You can use the projector on a tabletop or cart, you can permanently
mount it on a ceiling*
1
, or you can use MultiSync MT1020/MT820
LCD Projector to project images from behind the screen. The remote
INTRODUCTION1
control can be used wirelessly or with a cable, and you can even use
the remote control with the remote mouse receiver to operate the
mouse on your PC or Mac. But best of all, the MultiSync MT1020/
MT820 is an NEC LCD projector. That means you can depend on
years of reliable performance and crystal-clear presentations!
The features you’ll enjoy include:
Simple set up and operation.
A high-performance 250 watt metal halide lamp that delivers 700
ANSI lumens (MT1020: 600 ANSI lumens) and is guaranteed for
2000 hours of service or six months, whichever comes first.
A wireless remote control that operates the projector from any
angle.
A laser pointer that' s built into the remote control.
The power zoom control enables you to adjust the image to be
between 20 and 300 inches (measured diagonally).
You can choose between video modes depending on your source:
"normal" for a typical picture, "natural" for true color reproduc-
tion, and "camera" for use with a document camera or low APL
picture.
The "image capture" enables you to use the entire picture as a
background image or to create an image loop.
An image can be projected from in front or behind a screen, and
the projector can even be installed on the ceiling.
Supports most IBM VGA, S-VGA, XGA*
2
, SXGA(pseudo)*
3
,
Macintosh, or any other RGB signals within a horizontal fre-
quency range of 15.754 to 85 kHz (MT820: 15.754 to 60 kHz)
and a vertical frequency range of 50 to 85 Hz. This includes
NTSC, PAL, SECAM and NTSC4.43 standard video signals.
Note: Composite video standards are as follows:
NTSC: U.S. TV standard for video in U.S. and Canada.
PAL: TV standard used in western Europe
SECAM: TV standard used in France and Eastern Europe
NTSC4.43: TV standard used in Middle East countries
The remote control can be used with or without a cable, and you
can even use the remote to operate your PC or Macintosh mouse
wirelessly from across the room with the remote mouse receiver.
You can control your MultiSync MT1020/MT820 LCD Projector
with a PC.
The contemporary cabinet design is compact, easy to carry, and
complements any office, board room or auditorium.
*
1
Installing the MultiSync MT1020/MT820 LCD Projector on the
ceiling must be done by authorized NEC technicians.Consult
your NEC dealer for more information.
*
2
An XGA image (1028ן768) is commpressed into 800ן600 on
MT820.
*
3
An SXGA pseudo image (1280ן1024) is not supported by
MT820.
INTRODUCTION
13
14