Filter
Top Products
NDA-30007 Revision 3.0 Page 13
Conference Room Scheduler Installation Guide MAT Assignments
Chapter 4 MAT Assignments
This guide assumes that data settings that affect the operation of all OAI software
on a system-wide basis have already been assigned on the NEAX Maintenance
Administration Terminal (MAT). Such settings include, for instance, system index
values and assignment of Interface I/O Port Data in the Interface Processor (IP).
For more information about these system data settings and the MAT commands
described below for Conference Room Scheduler, refer to the OAI Module
Installation Manual for the NEAX2400 IMS, the NEAX2400 IMS Command
Manual, the NEAX2400 IMS Job Specification Manual, and the NEAX2400
IMS Programming Manual.
Conference Room Scheduler requires MAT assignment of the Mode Set Facility
(MSF) to an OAI-assigned function key on all D
terms
affected by application. This
process involves assigning the MSF and its Operation Code (Op-Code), configured
for Conference Room Scheduler in the APM Application Configuration option, to
one of the 14 OAI Key Codes. (The MSF Op-Codes range from 128 to 191;
available for on-screen viewing through the Providers command in the APM
Application Configuration option.) Each of the OAI Key Codes corresponds to an
AKY1 Function Key Index (FKI) value which is then assigned to the specific D
term
function key. This process is illustrated below.
Figure 4-1 OAI Function Key Assignment
A knowledge of the D
term
stations in the NEAX system and which ones will have
access to Conference Room Scheduler is necessary to using the following
commands:
APM
Application
Configuration
Designation of
Facility (Type)
and its Op-Code
for Use by
Conference
Room Scheduler
MAT
AOKC
Command
Assignment of
an OAI Key Code
(between 1 and 14)
to the Same
Facility Type
and Op-Code
1 <
2 <
3 <
4 <
5 <
6 <
7 <
8 <
9 <
10 <
11 <
12 <
13 <
14 <
> 34
> 35
> 36
> 37
> 38
> 39
> 40
> 41
> 42
> 43
> 44
> 45
> 46
> 47
PBX Correspondence of
AOKC AKYD
OAI Function
Key Codes
Key Indices
MAT
AKYD
Command
Assignment of
Corresponding
MAT Function
Key Index to a
specific D
term
Function Key
. . . . .
. . . . .
. . .
. . .