Filter
Top Products
NDA-30007 Revision 3.0 Page 5
Conference Room Scheduler Installation Guide Application Configuration
Step 3 – Facilities (Conf_Room_Sch only)
According to instructions in the APM Operations Manual, designate the
following NEAX2400 facilities for the Conf_Room_Sch component using the
Facilities command on the APM Configuration Entry screen:
MRFI Mode Release Facility (I)
MRFR Mode Release Facility (R)
MSF OAI Mode Set Facility
NTF Number Transfer Facility
TCFD Terminal Control Facility (D)
Note:
The same MSF identification number (i.e., from 128 to 192) that is selected in the
APM during Step 3 must be assigned to Conference Room Scheduler at the NEAX
MAT. For more information, see Chapter 4 .
Step 4 – Secondary OAI Configuration Parameters (Conf_Room_Sch only)
Using the OAI-Conf command on the APM Configuration Entry screen, make the
entry shown for each of the following parameters required by Conf_Room_Sch.
Use the instructions provided for this option in the APM Operations Manual:
Parameter Entry Definition
Database Name #1 /oai/db/cur/crminfofil Indicates the path name of the database
containing the conference room
information. This name must be the
first listed database. The database
filename (i.e.,
crminfofil
), listed here
with its path, should be used as the
name of the corresponding Application
Definition File (Refer to Chapter 3.)
Database Name #2 /oai/db/cur/crmidfile Indicates the path name of the database
containing the employee identification
data. This name must be the second
listed database. The database filename
(i.e.,
crmidfile
), listed here with its
path, should be used as the name of the
corresponding Application Definition
File (Refer to Chapter 3.)
Timeout Value #1 90 Designates the number of seconds
Conf_Room_Sch will wait for user
input before it will release the D
term
.
Tenant Number 0 Specifies the number of the tenant that
Conf_Room_Sch serves.