NEC NP610S Projector User Manual


  Open as PDF
of 114
 
81
6. Maintenance
Thissectiondescribesthesimplemaintenanceproceduresyoushouldfollowtocleantheltersandreplacethelamp.
1 Cleaning or Replacing the Filters
Theair-lterspongekeepsdustanddirtfromgettinginsidetheprojectorandshouldbefrequentlycleaned.Ifthelter
is dirty or clogged, your projector may overheat.
NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off.
To cancel the message, press any button on the projector cabinet or the remote control.
CAUTION
• Turnofftheprojector,turnoffthemainpowerswitchandunplugtheprojectorbeforereplacingthelters.
• Onlycleantheoutsideoftheltercoverwithavacuumcleaner.
• Donotattempttooperatetheprojectorwithouttheltercover.
Tocleantheair-lter:
Vacuumthelter-throughtheltercover.
Toreplacethelter(sponge):
1. Remove the filter cover (2 locations) by pushing up on the catch of the cover until you feel it detach.
2. Replace two filters.
(1) Gently peel off the filter (sponge) and clean the filter cover.
(2) Attach the new filter to the filter cover.
 previous next