Filter
Top Products
Figure 1
Step 6 Locate the two screws that
are supplied with the
IntelliBase
and attach
the IntelliBase
™
to the adapter
plate and
monitor as
shown in
Figure 3E.
Proceed to Page 10 to connect your MultiSync
®
monitor with IntelliBase
USB Hub and Audio to your system.
7
MultiSync Monitor Model Names
MultiSync XE21, XP21, E1100, E1100+, P1150 and P1250+
FOR ALL 21” MULTISYNC MONITORS
IT IS ADVISED THAT TWO PEOPLE ARE INVOLVED DURING THE ENTIRE
INSTALLATION PROCESS. ONCE THE INTELLIBASE HAS BEEN INSTALLED
ONTO YOUR 21” MONITOR, DO NOT ATTEMPT TO ADJUST THE TILT OF THE
MONITOR FROM THE BACK OF THE MONITOR UNIT. ONLY ADJUST THE TILT
FROM THE FRONT OF THE UNIT BY HOLDING ONTO THE LEFT AND RIGHT
SIDE OF THE MONITOR, TILTING EITHER UPWARDS OR DOWNWARDS. DO
NOT TILT THE MONITOR DOWNWARDS MORE THAN 5 DEGREES OR FORCE
THE MONITOR PAST THE FIRST STOP, AS THE MONITOR MAY BECOME
UNSTABLE, CAUSING POSSIBLE INJURY.
If you have any questions or comments, please contact NEC at 1-800-632-4662
Step 1 With the monitor
unplugged from your
system and wall outlet,
carefully turn the
monitor upside down
onto a firm table so
that the base is
facing up as shown
in Figure 1.
Figure 3E
INTELLIBASE
(BOTTOM VIEW)
ROTATE ADAPTER
PLATE UNTIL IT
ALIGNS WITH
THROUGH HOLES
ON THE BASE
MONITOR IN POSITION TO
REMOVE THE BASE AND ATTACH
INTELLIBASE USB HUB AND AUDIO
BASE
203 Eng Fr Cndn manual 12/21/98 11:20 AM Page 11