Filter
Top Products
E-6
Part Names of the Projector
Ventilation (outlet)
Heated air is exhausted from here
* This security slot supports the MicroSaver
®
Security System. MicroSaver
®
is a registered trademark of Kensington Microware Inc. The logo is
trademarked and owned by Kensington Microware Inc.
Built-in Security Slot ( )*
Adjustable Tilt Foot Lever
(See page E-18)
Attaching the lens cap
To attach the lens cap to the bottom with the supplied string and rivet:
Remote Sensor (See page E-10)
Controls (See page E-7)
Ventilation (inlet) / Filter Cover (inlet)
Lens Cap
Lens
Adjustable Tilt Foot (See page E-18)
AC Input
Connect the supplied power cable's two-
pin plug here, and plug the other end into
an active wall outlet. (See page E-16)
Main Power Switch
When you plug the supplied power cable into
an active wall outlet and turn on the Main
Power switch, the POWER indicator turns
orange and the projector is in standby mode.
(See page E-17)
Remote Sensor
(See page E-10)
Lamp Cover (See page E-30)
1. Thread the string through the hole on the lens cap and then tie a knot
in the string.
Lamp Cover Screw
Adjustable Tilt Foot Lever
(See page E-18)
Adjustable Tilt Foot
(See page E-18)
Focus Ring
Zoom Lever
Monaural Speaker (1W)
Attaching the supplied carrying handle
You can carry the projector by attaching the supplied carrying handle
securely to the projector.
To attach the supplied carrying handle, use the supplied flathead screw-
driver and two screws.
2. Use the rivet to attach the
string to the bottom of the
projector.
CAUTION:
When carrying the projector by the carrying handle, make sure the
two screws that attach the carrying handle to the projector cabinet
are tight.