Filter
Top Products
Connecting Your PC or Macintosh Computer
Connecting your PC or Macintosh computer to your MultiSync XV29 Plus
will enable you to display your computer's screen image. All of these
following display standards are supported:
VGA 640ן480 for graphics, VGA 640ן400 for graphics, VGA 640ן350
for graphics, VGA 720ן400 for text, VGA 720ן350 for text, SuperVGA
800ן600, and XGA 1024ן768 standards above 60 Hz such as Macintosh
at 640ן480, 832ן624 and 1024ן768.
To connect to a PC, Macintosh or computer equipped with a XGA/
SuperVGA/VGA adapter or compatible graphics adapter, simply:
1. Turn off the power to your monitor and computer.
2. If your PC does not support Super XGA/VGA/VGA you will need to
install an XGA/SuperVGA/VGA graphics board. Consult your
computer's owner's manual for your XGA/SuperVGA/VGA
configuration. If you need to install a new board, see the manual that
comes with your new graphics board for installation instructions.
3. Use the supplied RGB cable to connect your computer to the monitor. For
Macintosh, use a commercially avalable adapter between the D-Sub mini
15-pin connector of the supplied RGB cable and the D-Sub 15-pin
connector of your Macintosh.
4. Turn on the monitor and the computer.
NOTE: Refer to your computer's owner's manual for more information about your
computer's video output requirements and any special identification or
configuring your monitor's image and monitor may require.
Connecting Your VCR or Laser Disc Player
Using a common RCA cable and RCA audio cables (not provided) to
connect your VCR or laser disc player to your MultiSync XV29 Plus
monitor. To make these connections, simply:
1. Turn off the power to your monitor and VCR or laser disc player.
2. Connect one end of your RCA video cable to the video output connector
on the back of your VCR or laser disc player, connect the other end to the
VIDEO 1 or 2 input terminal(RCA-type) of the monitor. Use standard
RCA audio patch cords to connect the audio from your VCR or laser disc
player to your monitor (if your VCR or laser disc player has this
capability). Be careful to keep your right and left channel connections
correct for stereo sound.
3. Turn on the monitor and the VCR or laser disc player.
NOTE: Refer to your VCR or laser disc player owner's manual for more
information about your equipment's video output requirements.
NOTE: S-VIDEO IN terminals will take preference over VIDEO IN terminals
when a component is connected to each terminal and VIDEO 1 or 2 selected.
Connecting Your Document Camera
You can connect your MultiSync XV29 Plus monitor to a document camera.
To do so, simply:
1. Turn off the power to your monitor and document camera.
2. Use a standard video cable to connect your document camera to the
VIDEO 1 or 2 input terminal(RCA-type) of the monitor.
3. Turn on the monitor and the document camera.
NOTE: Refer to your document camera's owner's manual for more information
about your camera's video output requirements .
17
18