Filter
Top Products
NetComm NCT240 Management Guide Release 1.0
SNMP
This command is for configuring SNMP agent:
Syntax:
snmp <show|getcommunity|setcommunity|trapcommunity>
¾ show Display SNMP settings.
¾ getcommunity Set the SNMP GetRequest community.
¾ setcommunity Set the SNMP SetRequest community.
¾ trapsetting Set the SNMP TrapCommunity, trapIP, trapPort.
Command usage:
snmp show
snmp getcommunity <getcommunity>
snmp setcommunity <setcommunity>
trapsetting <trap community> <trap receiver IP> <trap port>
Server
Syntax: server <show| enable <telnet| ftp| web| ssh>|disable <telnet |ftp| web| ssh>|
port>
¾ show – display current server service status.
¾ enable – open the telnet, ftp, web or ssh server service
¾ disable – close the telnet, ftp, web or ssh server service
¾ port – show the port of a service
Command usage:
BAS/sys>server
The device's service status and port numbers information
Usage:
server <show| enable| disable| port><telnet| ftp| web| ssh>
show Display the device's service status and port numbers.
enable Turn on a service.
disable Turn off a service.
port Show the port of a service.
server command
42