Filter
Top Products
www.netcomm.com.au Rev. 2 - YML643
Page 16 NB1300 ADSL Modem
Trouble Shooting
Resetting the NB1300 ADSL Modem
When the Ethernet cable cannot be used due to an unknown or inaccessible IP address, you will
need to reset the NB1300 ADSL Modem to its factory defaults. To reset the ADSL Modem to
its factory defaults, use a ballpoint pen to press and hold the RESET button for 10 seconds.
Wait 30 seconds for the NB1300 ADSL Modem to reboot. The NB1300 ADSL Modem will
now have the default settings, including its default IP address of 192.168.1.1 and default
passwords
Registering your NetComm Product
To ensure that the conditions of your warranty are complied with, please go to the NetComm
web site for quick and easy registration of your product at
www.netcomm.com.au
Alternatively, you can use a copy of the Warranty Registration Form on the following page and
mail it to NetComm Limited, PO Box 1200, Lane Cove NSW 2066.
Contact Information
If you have any technical difficulties with your product, please do not hesitate to contact
NetComm’s Customer Support Department.
Email: support@netcomm.com.au
Fax: (02) 9424-2010
Web: www.netcomm.com.au
Trademarks and Notices
NetComm™ is a trademark of NetComm Limited. Windows® is a registered trademark of
Microsoft Corporation. Other brand and product names are trademarks or registered trademarks
of their respective holders. Information is subject to change without notice. All rights reserved.
Please note that the images used in this document may vary slightly from those of the actual
product. Specifications are accurate at the time of the preparation of this document but are
subject to change without notice.