Filter
Top Products
Model FS516/FS524 Fast Ethernet Switch Installation Guide
Before connecting the switch, be sure you review “Applications” for information
about determining the appropriate configuration for your networking needs.
To connect the switch:
1. Connect the devices to the 10/100 Mbps ports on the switch, using
Category 5 UTP cable and an RJ-45 plug.
2. Set the Normal/Uplink push button.
3. Set the FDX/AUTO toggle switches on the rear panel for the selected
duplex mode (the default setting is AUTO).
4. Connect one end of the DC power adapter cable to the power outlet on
the rear panel of the switch and the other end of the power adapter
cable to the wall outlet.
Refer to the following illustration when connecting the switch. Each of the
preceding steps has a corresponding reference number in the illustration.
Note: Ethernet specifications limit the cable length between your PC or server and the
switch to 328 feet (100 meters) in length.
Connect Devices to the Switch
Normal/Uplink
16
8
Power
Utilization%
10/100 Mbps
FS516
MODEL
Link
FDX
LinkFDX
13
1
Fast Ethernet Switch
16
PORT
10/100Mbps
Auto 10/100 Mbps
Utilization%
10/100 Mbps
9195FA
Normal/Uplink
18
FDX
AUTO
Duplex Mode
**
Normal/Uplink push button set to the Normal position for connection
to the server.
RJ-45
connector
1
2
3
4
*
*
For a typical configuration, set toggle switches to AUTO. For more
information, refer to "FDX/AUTO Duplex Toggle Switches."
**
100 Mbps
10 Mbps
Key