Filter
Top Products
Advanced Settings
19
Universal Dual Band WiFi Internet Adapter (WNCE3001)
• CTS/RTS Threshold (1-2347): The packet size that is used to determine whether the
Internet adapter should use the CSMA/CA (Carrier Sense Multiple Access with Collision
Avoidance) mechanism for wireless packet transmission.
Use Push 'N' Connect (WPS)
WPS (Wi-Fi Protected Setup) lets you connect to a wireless network without entering its
passphrase or wireless key. Instead, you use a button or enter a PIN to connect.
If you have a NETGEAR router, this feature is called Push 'N' Connect. Look for the or
symbol on the router to make sure the NETGEAR router supports WPS. For
non-NETGEAR routers, refer to the user manual to determine if the router supports WPS.
Note: The Universal Dual Band WiFi Internet Adapter (WNCE3001)
Installation Guide explains how to use WPS during installation.
To join a network using WPS after installation:
1. From the Internet adapter menu at http://www.mywifiext.net, under Setup, select WPS.
The following screen displays:
2. Select a radio button.
• Push 'N' Connect (recommended). Either click the
button or press the WPS
button on the rear panel of the Internet adapter.
• PIN Number. Select the radio button, and a PIN displays.
The Internet adapter tries to join the wireless network for 2 minutes if you are using Push
'N' Connect, or 4 minutes if you are using a PIN.
3. Go to the router.
• If you are using Push 'N' Connect, press the adapter’s WPS button.
• If you are using a PIN, log in to the router and type the PIN from your Internet adapter
in its WPS screen.
4. Go back to the computer that is connected to the Internet adapter, and make sure that you
are connected to the wireless network.