Filter
Top Products
25
B
B. Notification of Compliance
Maximum Wireless Signal Rate Derived from IEEE Standard 802.11 Specifications
Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic,
building materials and construction, and network overhead, lower actual data throughput rate.
Safety and Regulatory Notices
FCC Statement
The WNCE3001 has been tested and complies with the specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver’s
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any change or modification to the product not expressly approved by Netgear could void the user’s
authority to operate the device.
FCC RF Radiation Exposure and SAR Statements
SAR Statement
The NETGEAR WNCE3001 complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This WNCE3001 should be installed and operated with a minimum distance of 20 cm between the radiator and your
body. The WNCE3001 has been tested for body-worn Specific Absorption Rate (SAR) compliance. The FCC has
established detailed SAR requirements and has established that these requirements have been met while installed
in the host notebook computer.
For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels
is not possible. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This device and its antenna(s) must not be
co-located or operated in conjunction with any other antenna or transmitter. This device is going to be operated in a
5.15~5.25 GHz frequency range; it is restricted to an indoor environment only. Warning of high power radars as
primary users of bands 5252–5350 MHz and 5650–5850 MHz that could cause interference and/or damage to the
UNII device.