Filter
Top Products
NTI UNIMUX 2-PORT USB KVM SWITCH
7
Command Mode
Function: Keystroke:
Increment Port
Decrement Port
Toggle Scan Mode
ON and OFF
Sets scan time-out
period for each port.
Toggle Broadcast
Mode ON and OFF
Selects a specific
port
Select a different
control key combination
Select a specific
country code for
the keyboard
Print the code
version to a text
editor
Configure port to connect
To a MAC CPU
Configure port to connect
To a WINDOWS or SUN
CPU
Exit Command Mode
Default Value Reset
Default factory-set values for Command Mode entry key, Scan dwell time and country code can be restored by
following this procedure:
1. Disconnect power from the UNIMUX-USBV-2
2. Press and hold the CPU SELECT button on the switch
3. Re-connect power to the switch
4. Release the CPU SELECT button
CHORDED SEQUENCE- PRESS CONSECUTIVELY
AND KEEP KEYS PRESSED UNTIL ALL ARE PRESSED.
+
-
PRESS CONSECUTIVELY
or
PRESS EITHER KEY
KEY SYMBOLS LEGEND:
I
(select the next higher port
ex. 01 02)
or
D
or
(select the next lower port
ex. 02 01)
T
-
-
(xxx from 002 to 255. ie. t002
would set the time-out period
for 2 seconds)
-
(0-2)
x
(0-9)
x
(0-9)
x
Esc
Note: The user must exit Command
Mode to use the CPU(s) in the
selected mode.
P
-
-
(P0x would be P01 or P02.)
(1-2)
x
0
L
-
-
(Lxx would be L00-L34, see Country Codes Table on page 11
x x
V
(This will print the version of the code in the KEEMUX-USBV-2U switch to a text editor
window for use when troubleshooting the switch)
S
(When toggled to ON, Scan Mode will be indicated the LED for only the active CPU
flashing ON and OFF .)
B
(When toggled to ON, Broadcast Mode will be indicated by both LEDs cycling alternately
ON and OFF in rapid intervals.)
C
x = the desired key (This will replace the Ctrl +
`
sequence to enter
Command Mode)
x
-
+
W
x
(x= 1 or 2 <W> + <1> will disable function on Port 1
<W> + <2> will disable function on Port 2. Keyboard
LED's will flash once to confirm command. )
+
M
x
(x= 1 or 2 <M> + <1> will enable function on Port 1
<M> + <2> will enable function on Port 2. Keyboard
LED's will flash once to confirm command. )