Filter
Top Products
May 2003 Installing the server and connecting the peripheral devices
Part 2: 1001rp Server Hardware Installation 67
Requirements
For installation, you require a Phillips No. 1 screwdriver.
To install the software feature key adapter
1 Ensure that there is no cable connected to the parallel port.
Note: The parallel port is also known as the printer port or LPT1. It is
located at the back of the server. See the diagram on page 59.
2 Plug the male end of the adapter into the parallel port.
3 Tighten the connector screws.
What’s next?
Continue with “Connecting the server to power” on page 68.