Filter
Top Products
12 Configuration
CTA 500
dm
On Line Guide P0873832 Issue 05
Configuring the PC serial port
¥ Verify the port baud rate is set to 115,200 (default) using the
Serial Interface Rate command.
¥ Set the character length, using the Set Data Bits command and
parity, using the Set Parity command. The default is 8 bits with
no parity (recommended).
¥ Set the ßow control using the Flow Control command. The
default is hardware (recommended).
Installing CTA 500
dm
and Norstar TAPI Service Provider software
1. From the Norstar Personal Productivity Suite main screen, select
the Language, and then the Installation option.
2. After accepting the licensing terms and reading the TAPI
requirements (if displayed), select the Install option.
3. Select the CTA 500dm from the right hand side of the dialog box
(under the Drivers section).
4. On the left hand side of the dialog box, select the components
you wish to install:
Drivers Ñ the required drivers and conÞguration utility for the
CTA 500dm
Toolkits Ñ CTE, Norstar TAPI Service Provider (TSP)
Applications
5. Follow the on-screen instructions to select automatic
conÞguration, and to select the proper communications port.
6. Choose the appropriate settings for your installation.