Filter
Top Products
6
2 Verify that the GBIC is the correct model for your network
configuration (Table 1 on page 4).
3 Remove the dust cover from the GBIC’s optical bores.
4 Grasp the GBIC between your thumb and forefinger.
5 Insert the GBIC into the slot on the front panel of the Gigabit
Ethernet switching module (Figure 3) .
Figure 3 Inserting the GBIC into the switching module
Removing a GBIC
This section lists the steps for removing a GBIC.
To remove a GBIC:
1 Disconnect the network fiber cable from the GBIC
connector.
Note: GBICs are keyed to prevent incorrect insertion.
CWGBIC.fm Page 6 Wednesday, December 12, 2001 11:26 AM