Filter
Top Products
May 2003 Preparing for installation
Part 2: 1001rp Server Hardware Installation 35
Inspecting the server interior
Introduction
You should perform a visual inspection for loose components, foreign
matter, or shipping damage inside the server.
To inspect the server interior
1 Carefully check all the cards to ensure they are fully seated on the
baseboard.
2 Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3 Review the slot locations (see “Slot definition and slot numbering” on
page 14).
4 Do one of the following:
.
CAUTION
Risk of equipment damage
When working with interior components, use an ESD wrist
strap to protect static-sensitive components.
IF THEN
you observe any damage contact your Nortel Networks
technical support representative.
components have become
loose
secure them.
Refer to the procedures in Part 5 of
the CallPilot Installation and
Configuration binder.