Rev. 041008
26
SNTP General
•
SNTP Client: Enables/Disables the SNTP Client to contact the configured server on UDP port 123 and set the local time
Default:
disable
• Server Name: Sets the NTP server name or IP address to which the SNTP Client has to contact to update the time
Default:
127.0.0.1
• Time Zone: Sets the time zone
Default:
UTC
• Time Zone offset: Sets the offset time from UTC
Default:
+00:00 (+/-hh:mm)
• Polling Time: Sets the polling time at which SNTP client requests the server to update the time
Default:
300 minutes
• Daylight Saving: Enables/Disables the Day Light Saving Mode
Default:
enable
• Daylight Saving offset: Sets the offset to use during the Day Light Saving Mode
Default:
+60 (+/-mm)
SNTP Daylight Saving Configuration
•
Start Ordinal: Sets the start ordinal to use during the Day Light Saving Mode. Options - first/second/third/forth/last
Default:
first
• End Ordinal: Sets the last ordinal to use during the Day Light Saving Mode. Options - first/second/third/forth/last
Default:
last
• Start Month: Sets the start month to use during the Day Light Saving Mode
Default:
april
• End Month: Sets the end month to use during the Day Light Saving Mode
Default:
october
• Start Day: Sets the start weekday to use during the Day Light Saving Mode
Default:
sunday
• End Day: Sets the end weekday to use during the Day Light Saving Mode
Default:
sunday
• Start Time: Sets the start time to use during the Day Light Saving Mode
Default:
02:00 (hh:mm)
• End Time: Sets the end time to use during the Day Light Saving Mode.
Default:
02:00 (hh:mm)
Commands
•
User can enter any "set" commands as per the manual
View Statistics
•
Bridge: Displays the Bridge Statistics only when bridge is enabled
• eth0: Displays Ethernet Statistics
• serial: Displays Serial Statistics
• PPP: Displays PPP Statistics only when PPP is enabled
• Users: Displays the Default and Added users of the module
• System Information: Displays the System information of the module. Processor details, Uptime, Memory utilization, Flash Memory map, Version, Date,
Binary details
Save
•
Upon clicking Save button, it prompts for confirmation
• If selected OK, the modified configuration is written into flash and if the box may reboot for few configuration changes. After few seconds, the
default.html/http-s0.html page will be launched again as per configuration. If the page is not launched, check the IP address and HTTP configuration status
• If selected CANCEL, the browser is redirected to General Configuration page
Restore Defaults
•
Upon clicking Restore Defaults button, it prompts for confirmation
• If selected OK, the configuration is restored to factory defaults and redirected to General Configuration page. User need to click save button to save the
configuration
• If selected CANCEL, the browser is redirected to General Configuration page