Filter
Top Products
42 Microline 390/391 Turbo
|
Setting Top of Form, Forms Tear-Off ON
(Step A)
!
If you turn the platen knob when the printer is turned
on, you will cause the Top of Form to mis-align. Always
turn the printer off before turning the platen knob!
!
Always determine the status of the Forms Tear-Off menu
setting BEFORE setting the Top of Form. Refer to
“Using Your Printer, Top of Form, Forms Tear-Off
Status (ON or OFF).”
1 Turn the printer ON.
2 Park the paper.
3 With paper out of the unit, (red alarm light should be on)
press SHIFT (1) and QUIET/TOF (5) to reset the current
Top of Form.
4 Press FF/LOAD (3) to load the paper.
5 Press SEL/MENU (6) to take the printer off line.
The SEL light goes out.
6 Wait until the paper moves up to the tear position, then
press and hold TEAR (4).
The paper moves to the current Top of Form.
Keep pressing and holding TEAR.
7 Press and hold SHIFT and release TEAR.