Filter
Top Products
2
5. Plug the cable into the connector on the left side of the
printer.
6. Install the center guides and rear sheet supports.
Install the center guides by snapping them onto the
round shaft (1), then securing the top hooks to the
square shaft (2). Install the rear supports by sliding
them onto the square shaft (2).
The configuration you use (center supports = 1, rear
supports = 2, paper guides = 3) depends on the
type of media you plan to use:
For Wide Paper:
For Narrow Paper:
For Cards:
7. Turn on the printer.
Installation: Rear Mount
Note:
The Cut Sheet Feeder can only be mounted at
the rear if the optional Rear Push Tractor is not
installed.
1. Unpack the cut sheet feeder. Remove the shipping
materials.
2. Turn off the printer.
Front F6_06.jpg
Front F6_08.jpg
F6_21.jpg
Front F6_11.jpg
F6_22.jpg
F6_01 Rear.jpg