Filter
Top Products
3
3. Remove the gear cover (1). Push up on the tab (2),
then twist it off. This provides access to the mounting
post (3).
4. Remove the stacker (1) and the stacker support (2).
Keep the stacker handy: you’ll need it later in the
installation. Store the stacker support in case you ever
decide to remove the rear push tractor.
5. Slip the U-shaped brackets (1) at either end of the CSF
under the posts (2), inside the stacker support bracket,
behind the stacker roller (3). Gently lower the CSF into
place.
6. Plug the cable into the connector on the right side of the
printer.
7. Install the center guides and rear sheet supports.
Install the center guides by snapping them onto the
round shaft (1), then securing the top hooks to the
square shaft (2). Install the rear supports by sliding
them onto the square shaft (2). (Continued on next
page
.
)
The configuration you use (center supports = 1, rear
supports = 2, paper guides = 3) depends on the
type of media you plan to use:
For Wide Paper:
F6_2_03.jpg
Rear F6_13a.JPG
Rear F6_14.jpg
Rear F6_15.jpg
Rear F6_07.jpg
F6_21.jpg