Filter
Top Products
Introduction and Installation
OMG-PCI-DIO48 Page 2
System Installation
The OMG-PCI-DIO48 can be installed in any of the PCI expansion slots.
1. Turn off PC power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available PCI slot and remove the blank metal slot cover.
4. Remove the clamping portion of the bracket from the card.
5. Gently insert the OMG-PCI-DIO48 into the slot. Make sure that the
adapter is seated properly.
6. Feed the two 50-pin ribbon cables through the cutout bracket and
connect them to the card.
7. Replace the bracket retaining screw.
8. Install the clamping portion of the bracket
9. Replace the computer cover.
10. Connect the power cord. Installation is complete.