Filter
Top Products
Page 5
Scanning
If the wand has a trigger switch, press button near
the tip. Red LED illumination will emit from the
ruby ball tip of the wand. If the wand does not
have a trigger switch, then the red LED will remain
illuminated as long as the computer system is on.
1. Place the tip of the wand about ¼ to ½ inch
to the right or left of the bar code. The wand
top must make contact with the bar code
label.
2. Move the wand over the bar code label quickly
with uniform speed. For maximum perfor-
mance, slightly tilt the wand while scanning.
3. The wand will beep to indicate an audible
good read (if it does not beep, confirm that
beeper is enabled (page 38). If the wand has
a Good Read LED indicator (MSH-220 only),
it will illuminate indicating a good read.
NOTE: The wand will read all bar code symbologies
listed in the menu section of this Guide.