Filter
Top Products
19
English
Maintenance
w Changing the lamp
Make sure the projection display has cooled for at least 30 minutes before changing
the lamp. After you slide the lamp latch and open the lamp door, you will see two lamps
inside; one is in “usage” position, the other is in “spare” position. Refer to the lamp
changing directions below.
Lamp Changing Directions:
Warning: Lamp compartment is hot! Allow it to cool before changing lamps!
Notice: Use only USHIO or OSRAM HLX 64663T EVD 36V 400W lamp. Please
contact your local supplier or service center.
Slide the lamp latch; open the lamp compartment.
Move the lamp assembly by the long pin.
Slide the lamp assembly sideways to place the
spare lamp into the “usage” position. Remove the
used lamp.
Hold the new lamp with a plastic bag or clean cloth
and then push it firmly into the socket. (Finger oil,
dust or water will damage the lamp.)
Be sure the lamp assembly is set firmly back in
position. Then close the lamp door.
Lamp Assembly
Lamp Latch
Long Pin
Lamp Door
“Usage” Position