Filter
Top Products
11
... English
Installation
Power/
Standby
1
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn red.
3. Turn on the lamp by pressing “Power/Standby” button on
the control panel. n
The startup screen will display for 30 seconds and the Power
LED will flash green.
When the startup screen disappears, the Power LED will turn
green.
4. Turn on your source (computer, notebook, video player ,etc.).
The projector will detect your source automatically.
If you connect multiple sources at the same time, use the “Source”
button on the control panel to switch.
Powering On/Off the Projector
Turn on the
projector first and then
the signal sources.