Filter
Top Products
English
3
Usage Notice
Precautions
Please follow all warnings, precautions and mainte-
nance as recommended in this user’s guide.
When the lamp reaches
the end of its life, the
projector will not
turn back on until the
lamp module has been
replaced. To replace
the lamp, follow the
procedures listed under
“Replacing the Lamp”
section on page 41.
▀■ Warning-
Do not look into the projector’s lens when the
lamp is on. The bright light may hurt your
eyes.
▀■ Warning-
To reduce the risk of fire or electric shock, do
not expose this projector to rain or moisture.
▀■ Warning-
Please do not open or disassemble the projec-
tor as this may cause electric shock.
▀■ Warning-
When replacing the lamp, please allow unit to
cool down, and follow all replacement instruc-
tions. See page 41.
▀■ Warning-
This projector will detect the life of the lamp
itself. Please be sure to change the lamp when
it shows warning messages.
▀■ Warning-
Reset the “Lamp Reset” function from the on-
screen display “System|Lamp Setting” menu
after replacing the lamp module (refer to page
35).
▀■ Warning-
When switching the projector off, please
ensure the cooling cycle has been completed
before disconnecting power. Allow 90 seconds
for the projector to cool down.
▀■ Warning-
Do not use lens cap when projector is in
operation.
▀■ Warning-
When the lamp is approaching to the end
of its life time, the message “Replacement
suggested” will show on the screen. Please
contact your local reseller or service center to
change the lamp as soon as possible.
Note
Note