Filter
Top Products
FW-SP-250
The FW-SP-250 is a two-piece combined FLEXware 250 top cover and FLEXware Surge Protector. It
replaces an existing FLEXware 250 cover, attaching at the AC end of the FLEXware 250.
Procedure
The FLEXware 250 AC should already be installed (see FW250 AC instructions) and all AC and DC
power shut o .
(4) Replace the standard FLEXware 250 AC cover
with the FW-SP-250, securing it with six Phillips
screws (four from the removed FW250 AC cover
and two additional that come with the FW-SP-
250).
Figure 8: FLEXware 250 AC
(3) Remove the standard FLEXware 250
AC cover (secured by four Phillips screws).
(2) Remove the AC Wiring
Compartment cover (secured by
two Phillips screws).
(1) Remove the DCC or Turbo
cover (secured by four Phillips
screws) and the two battery caps.
Tools Required to Install: Purpose:
• Slotted screwdriver • Wiring to the AC wiring block
• Phillips screwdriver • Remove and install covers
• 13 mm socket (torque ratchet) • Securing wires to FX DC terminals
• Utility knife • Removing plastic knockouts
• 4 mm Allen wrench • Removing and installing FX M5 hex bolts
10
Figure 9: FW-SP-250