Filter
Top Products
55
Function
08 SPECIAL TRAY 2 Selects the paper tray to use for special paper. 1:NONE
1:NONE / 2:TRAY-1 / 3:TRAY-2 / 4:TRAY-3 /
5:TRAY-4 / 6:BYPASS
(Only available when optional TRAY-2 and 3/4
are installed. see page 69)
09 KEY/TOUCH BEEP Selects the default key sound level. 2:SOFT
1:OFF / 2:SOFT / 3:LOUD
10 BYPASS SET BEEP Selects whether to sound a Beep when paper is 1:INVALID
set on the Sheet Bypass.
1:INVALID / 2:VALID
11 ORIG.SET BEEP ADF Selects whether to sound a Beep when paper is 2:VALID
placed on the ADF.
1:INVALID / 2:VALID
12 PAPER OUT ROTATE
Machine will automatically rotate the image to
1:OFF
accommodate the orientation of the paper in another
Tray and print when the selected Tray is empty.
1:OFF / 2:ON
13 DEPT. COUNTER MODE Monitors the copy usage of each department. Consult your
1:TOTAL COUNTER authorized
2:DEPT. COUNTER Panasonic dealer
3:DEPARTMENT LIST
16 LANGUAGE PRIORITY Selects whether to enable the language 1:OFF
selection menu to display when the machine
comes out of the Energy Saver Mode, or when
the RESET button is pressed once.
1:OFF / 2:ON
17 DATE & TIME Sets the date and time.
(Month, Day, Year, Time)
Input the date and time with Cursor Keys and
Keypad.
18 DAYLIGHT TIME Set Daylight Time according to your local 2: MAR 2nd
regulation.
1: OFF : Daylight Time is not applied
2: MAR 2nd : From 2 a.m. on the 2nd Sunday
of March to 2 a.m. on the 1st
Sunday of November
• The date setting shown above reflects the New
Regulation starting in 2007. In 2006, the Daylight
Time will end on the Last Sunday of October.
3: APR 1st : From 2 a.m. on the 1st Sunday of
April to 2 a.m. on the Last Sunday
of October
19 IP ADDRESS (DHCP)
*
1,
*
2
Displays the IP Address which was reserved by
DHCP server.
20 SUBNET MASK(DHCP)
*
1,
*
2
Displays the Subnet Mask Address which was
reserved by DHCP server.
21 DEF. G/W IP(DHCP)
*
1,
*
2
Displays the Gateway IP Address which was
reserved by DHCP server.
22 DHCP DEFAULT
∗
3
Selects whether to enable the DHCP. 2:VALID
1:INVALID / 2:VALID
■ General Settings (For Key Operator) (Continued)
No.
Modes Function
Initial
Setting
NOTE ∗1When setting other than DHCP server Network settings, Parameter No. 22 (DHCP DEFAULT) should be set to “INVALID”
first, then setup Parameters No.19 to 21.
∗2 When Parameters No. 19 to 23 (except 22) are set, cycle the power by turning the Power Switch on the Right Side of the
machine OFF and ON.
∗3 When not connecting to LAN, the setting of DHCP should be on INVALID. When the setting of DHCP is on VALID, and the
machine is in Shutdown Mode, the machine will not answer an incoming Fax call.
<continue on the next page.>