Filter
Top Products
20
Getting StartedUseful InformationTroubleshootingAppendix
Reinstalling Software
Preparation
z Prepare the following items:
• The Product Recovery DVD-ROM (included)
• Panasonic CD/DVD drive (included)
z Remove all peripherals (except for the CD/DVD drive).
z Connect the AC adaptor and do not remove it until reinstallation is complete.
NOTE
z Even if reinstallation is performed, the number of times of DVD’s region code setting will not be reset.
1 Turn off the computer and insert the CD/DVD drive into the multimedia pocket
(Î Reference Manual “Multimedia Pocket”).
2 Turn on the computer, and press
F2
several times while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
z If the password is requested, enter the Supervisor Password.
3 Write down all of the contents of the Setup Utility and press
F9
.
At the confirmation message, select [Yes] and press
Enter
.
4 Select the [Boot] menu, then select [IDE MP] and press
F6
until [IDE MP] is at the top of
the boot priority order.
5 Select the [Security] menu and set [CD/DVD Operation] to [Enable].
6 Set the Product Recovery DVD-ROM into the CD/DVD drive.
7 Press
F10
.
At the confirmation message, select [Yes] and press
Enter
.
The computer will restart.
z When the hard disk backup function has been enabled, the confirmation message appears to inform that the
backup function will be disabled, and the backup area and data will be erased. Press
Y
to proceed.
8 Press
1
to execute [1. [Recovery]].
The License Agreement screen appears.
z To cancel partway, press
0
.
9 Press
1
to select [1. Yes, I agree to the provisions above and wish to continue!].
10 Select the settings.
z [2]: Enter the size of operating system partition and press
Enter
.
You cannot create the hard disk backup area if you select [2].
(The size of data partition will be determined by subtracting the operating system partition size from the
maximum size.)
[3]: Windows will be installed in the first partition.
(The size of the first partition must be 20 GB or more. If smaller, installation will not be possible.)
z When the hard disk backup function has been enabled, the confirmation message appears to inform that the
backup function will be disabled, and the backup area and data will be erased. Press
Y
to proceed. If the
reboot message appears, press
R
to proceed.
At the confirmation message, press
Y
.
Reinstallation starts automatically. (It will take approximately 20 minutes.)
z Do not interrupt reinstallation, for example by turning off the computer or pressing
Ctrl
+
Alt
+
Del
. Other-
wise reinstallation may become unavailable as Windows may not start up or the data may be corrupted.
11 Remove the Product Recovery DVD-ROM, and then press any key to turn off the com-
puter.
When you reinstall the software, the hard disk data will be erased. Back up important data to other media or an exter-
nal hard disk before reinstallation.
Reinstalling software will return the computer to the default condition. The hard disk backup area and the backup data
(Î page 16) will be erased. (If you reinstall Windows in the first partition, the backup area and data will not be
erased.) Even if the data is stored in partitions on the hard disk, it may be erased or corrupted.
CF-74MK2_X_E_OI_XA.book 20 ページ ２００６年９月１１日 月曜日 午前９時１８分