Filter
Top Products
Preparation
About Your Projector
ENGLISH - 14
Remote control
POWER ON and POWER STANDBY
buttons
POWER ON: Starts
the projection while in
the standby mode.
POWER STANDBY: Returns to the
standby mode. (page 19)
INPUT SELECT buttons
These buttons
select the RGB1,
RGB2, DVI-D,
VIDEO, S-VIDEO
and SDI terminals. (page 22)
MENU buttons
Displays and clears the main
menu, and returns to the
previous menu when the menu
is displayed. (page 27)
ON SCREEN button
Displays and clears the on
screen indications. (page 22)
TEST PATTERN button
Displays the test pattern.
(page 22)
Numeric (0 - 9) buttons
Enter ID number of the remote control
and adjustment values of menu items.
(page 15)
STATUS button
Displays projector
information. (page 23)
Navigation and ENTER buttons
Navigate through the
menu items with F G
I H, and activate them
with the ENTER button.
(page 27)
Remote control indicator
Flashes by pressing any buttons.
(page 21)
AUTO SETUP
Pressing this button while
projecting an image
automatically corrects the
picture positioning on the screen.
While the auto setup feature is active,
a message “PROGRESS” appears on
the screen. (page 21)
SHUTTER button
Pressing this button toggles
the projector’s internal
mechanical shutter to black out
the projector. (page 22)
ASPECT button
Switches the image aspect
ratio. (page 22)
LENS buttons
These buttons
are used
together with
F G I H to adjust focus, zoom and
shift by the projection lens. (page 19)
FUNCTION button
Assign the frequently use
functions from options for
shortcut. (page 23)
DEFAULT button
Restores the default factory
setting. (page 23)
ID buttons
ALL: Makes the remote
control available to
control any ID
projectors.
SET: Specifies the ID of the remote
control. (page 15)
Top view
Remote control signal emitters
Bottom view
Remote control wired terminal
Battery compartment
1.Press the tab and lift up the cover.
2.Insert the batteries according to the polarity
diagram indicated inside.
B
A
NOTE:
• Switch on the POWER button of the projector body that is located near the terminals before using the remote control.
• Do not drop the remote control.
• Avoid contact with liquids or moisture.
• Use manganese batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorized Service Center for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• See “Remote control operation” on page 21.