Filter
Top Products
Basic Operation
Projecting
ENGLISH - 20
Switching off the projector
1. Press the POWER STANDBY button.
The confirmation screen will be displayed.
2. Select OK and press the ENTER button, or press the
POWER STANDBY button again.
The projection of the image stops, and the power indicator
of the projector lights up orange. The cooling fan keeps
running.
3. When the power indicator of the projector turns to red,
switch the POWER switch to OFF.
When the power indicator of the projector turns to red, the
cooling fan stops.
While the cooling fan is still running, never turn off the
POWER switch, nor unplug the power cord from the wall
outlet.
Direct power off function
The power supplied internally causes the cooling fan to
continue operating and cool off in the event that the
power has failed or even after the power cord is
accidentally disconnected immediately after the power
has been turned off.
Lens home position
1. Press and hold the LENS button of the control button on
the projector or SHIFT button of the remote control for
3 seconds or more.
The HOME POSITION setup screen will be displayed for
5 seconds.
2. Press the ENTER button before the setup screen
disappeared.
While the lens returning to the home position, a message
“PROGRESS” appears on the screen.
Adjustment range after lens
position (optical shift)
Do not move the lens beyond the bounds of the shift
range as this may cause a change in the focus. This
limitation is to protect the parts of the projector. Using the
standard projection position as the reference, the optical
axis shift function makes it possible to adjust the
projection position in the ranges shown in the figures
below.
NOTE:
• In the cooling state after the power is turned off, the lamp will
not light up even if the power is turned on. To light up the lamp,
turn on the power supply again when the lamp has been
cooled sufficiently. Failure to observe this may shorten the
lamp life.
NOTE:
• When the lamp has been cooled by the direct power off
function, it sometimes takes longer than usual for the lamp to
light up again.
• While the cooling fan is operating, do not place the projector
inside a box or bag.
POWER STANDBY button
NOTE:
• The home position for the projection lens is the lens position
when the lens is being replaced or when the projector is being
stored away, and it is not the optical center of the screen.
PT-DZ6710U/PT-DZ6700U/PT-D6000U/
PT-D5000U
PT-DW6300U
Standard projection position
Standard projection position