Filter
Top Products
ENGLISH - 19
Basic Operation
Projecting
Switching on the projector
When using an optional lens, install a projection lens
before switch on the projector.
1. Connect the supplied power cord (220 - 240 V AC,
50 Hz/60 Hz) to the AC IN terminal.
2. Remove the projection lens cover from the lens.
3. Switch the POWER switch on that is on the side of the
projector.
The power indicator lamp on the projector will flash in red.
After a short period, the indicator will illuminate and the
projector will enter standby mode.
4. Press the POWER ON button
The power indicator lamp illuminates in green and soon the
image is projected on the screen.
.
Making adjustment and selection
It is recommended that the projector be allowed to warm
up for at least 30 minutes before any adjustments are
made to the focus.
1. Roughly adjust the focus of the lens.
2. Select and set the projection scheme of
INSTALLATION and COOLING CONDITION settings in
PROJECTOR SETUP menu.
3. Select the input signal by pressing the INPUT SELECT
buttons.
4. Adjust the vertical tilt of the projector with the front leg
adjusters.
5. Adjust the shift position of the projection.
If the input signal is RGB signal, additionally press the
AUTO SETUP button to adjust the position of the image.
6. Zoom the lens so the image fills the screen.
7. Readjust the focus.
8. Readjust the zoom so that the image size fits in the
screen.
Adjusting focus, zoom and shift
Projecting a image
NOTE:
• If the projector is powered up at about 0 °C (32 °F), a warm-
up period of approximately 5 minutes may be necessary to
start projection. The temperature monitor (TEMP) lamp lights
up during the warm-up period. When the warm-up is
completed, the temperature monitor (TEMP) lamp turns off
and the image is projected on the screen.
• If the temperature of the operating environment is low and
warm-up takes more than 5 minutes, the projector will judge
that a problem has occurred and the power will be turned off
automatically. If this happens, increase the temperature
around the projector so that it is
0 °C (32 °F) or higher, and
then turn on the POWER switch and press the POWER ON
button again.
POWER switch
AC IN terminal
POWER ON button
Control buttons of the
projector
Pressing the LENS button changes the
setup screen in order of FOCUS, ZOOM
and SHIFT. Press F G I H to adjust.
Remote control buttons
Press FOCUS, ZOOM or SHIFT button
to display the setup screen. Press F G
I H to adjust.
CAUTION:
• Be careful not to catch your fingers between the lens and
shroud when shifting the lens.
NOTE:
• The setup screen will be displayed with the optional fixed lens
though, it will not be functioning.
• Pressing F G I or H for 3 seconds or more, performance
the adjustment faster.
LENS button
INPUT SELECT buttons