Filter
Top Products
13
Tighten the screw to clamp the cable and wiring the cable as shown in the fig. (10)-4.
(11) Slide USB cable cover as shown in the fig. (11)-1. In case of Dallas KEY reader, slide the
USB cable cover with care to avoid the cable from the rib of the USB cable cover as shown
in the fig. (11)-2.
(12) Put the supplied 2 peripheral screws in from the front side of the ID module unit and tighten
the screws using a screwdriver from the rear side to secure it.
(13) Install Display Unit according to Display Unit Installation.
(1)
(4)
(3)
(5)
(7)
(6)
Use only
Dallas KEY reader
(9)-3
(
10
)
-1
(9)-4
(8)
(9)-2
(9)-1
Hinge cover side (salient)
(10)-2
(10)-4
(10)-3