Filter
Top Products
ENGLISH - 10
Preparation
Read this first
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
J LANGUAGE
Select the required language setting.
Press F G I H buttons of the Remote control or
Control panel on the projector to highlight the
required language, and press ENTER to proceed to
the next setting.
J OPTION
Select the current projection method, screen size
and fan speed setting. If you need return to the
previous setting, press the RETURTN button.
INSTALLATION
Press I H buttons of the Remote control or
Control panel on the projector to select the
required installation method. Press G to proceed to
the HIGHLAND setting.
SCREEN FORMAT
Select the required screen format by pressing I
H.
16:10 When project on a 16:10 or 4:3
screen.
16:9 When project on a 16:9 screen.
HIGHLAND
If you use the projector at high elevation, the
HIGHLAND setting need to be ON to set the fan
speed high. Press I H to select the required
option. If you need to return to the INSTALLATION,
press F .
OFF The fan speed is low.
ON The fan speed is high.
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialized. See “INITIALIZE ALL” on page 36.
You can change the settings from the MAIN MENU. See “Menu Navigation” on page 27.
Minimum required setting screen
LANGUAGE
SELECT
PLEASE SELECT LANGUAGE
ENTER
INSTALLATION
OPTION
FRONT/DESK
HIGHLAND
OFF
SCREEN FORMAT
16:10
SELECT
ENTER
RETURN
FRONT/DESK
Setting on a desk/floor and
projecting from front
FRONT/CEILING
Mounting in the ceiling and
projecting from front
REAR/DESK
Setting on a desk/floor and
projecting from rear
REAR/CEILING
Mounting in the ceiling and
projecting from rear
NOTE:
• At 1 400 m (4 593 ft) above sea level, the setting must
be ON.
• The loudness of fan noise depends on the HIGHLAND
setting.