Filter
Top Products
76
Controls and Their Functions
PREVIEW OUT
CAM CONT IN
5
PAN/TILT
CONTROL IN
BLACK
BURST OUT
PREVIEW OUT
CAM CONT IN
4
PAN/TILT
CONTROL IN
BLACK
BURST OUT
PREVIEW OUT
TO CONTROL PANEL TO PAN/TILT HEAD HUB
CAM CONT IN
3
PAN/TILT
CONTROL IN
BLACK
BURST OUT
PREVIEW OUT
CAM CONT IN
2
PAN/TILT
CONTROL IN
BLACK
BURST OUT
PREVIEW OUT
CAM CONT IN
1
PAN/TILT
CONTROL IN
BLACK
BURST OUT
BLACK
BURST
OUT
PREVIEW IN
CAM CONT OUT
PAN/TILT
CONTROL OUT
+-
DC12V IN
9
8
45
7
;
:
6 3
3
DC +12 V Input Connector [DC12 V IN]
(4-pin Cannon Connector)
Connect the AW-PS505 AC adapter
(sold separately) to this connector.
4
Pan/Tilt Head Control Signal Output
Connector [TO PAN/TILT HEAD HUB
PAN/TILT CONTROL OUT] (RJ-45 8-
pin Modular Jack)
Connect this connector to the control
signal input connector [P/T CONTROL
IN] of the AW-PH300 or AW-PH600
pan/tilt head, or to the pan/tilt control
signal input connector [TO CONTROL
PANEL PAN/TILT CONTROL IN] of the
AW-HB505 multi port hub using a
10BASE-T (UTP category 5) straight
cable.
5
Preview Video Signal Input
Connector [TO PAN/TILT HEAD HUB
PREVIEW IN] (BNC Connector)
Connect this connector to the video
signal output connector [VIDEO OUT] of
the pan/tilt head, or to the preview video
signal output connector [TO CONTROL
PANEL PREVIEW OUT] of the multi
port hub using a coaxial cable (5C-2V
equivalent).
<Note>
In a system incorporating the AW-
RP301 or AW-RP305, the control panel
is not equipped with a video signal cable
compensation circuit. It may therefore
be necessary to use a separate cable
compensation device in some cases.
$
Rear Panel
Controls and Their Functions
$
Front Panel
1
Power Indicator LED [POWER]
This indicator lights (red) when the
power switch
2
is at the ON position. It
is dark when the power switch
2
is at
the OFF position.
2
Power Switch [POWER ON/OFF]
Placing this switch at the ON position
when the AC adapter is connected and
turned on supplies power to the multi
control hub (power indicator LED lights).
Placing it at the OFF position cuts off
the power.
<Note>
This switch must be at the ON position
in order to control the camera and
pan/tilt head from each control panel.
POWER
OFF ON
1
2
Multi Control Hub AW–