Filter
Top Products
5
Power switch
This is the main power switch.
When the power is ON, the LED (green) above the
switch lights.
1
2
INPUT selector button
This is used to select the signal input, and each time it is
pressed, the input is switched in the following sequence:
LINE A > LINE B > CMPNT> SDI > LINE A.
<Note>
The SDI signal input can be selected only when the BT-
YA210G, available as an optional accessory, is installed.
5
MENU selector buttons
These are used to display the menus and perform the
adjustments and settings.
MENU/EXIT:Press this button to exit the menu
display and menu. Further, if this button
is pressed after the menu item has been
selected, the menu will be exited with
the item entered.
WWXX
: Press these buttons to move the cursor
up or down or to select menu items.
ENTER: Press this button to select menu items or
enter settings.
4
3
BLUE ONLY button
The chroma and phase can be adjusted more accurately
using SMPTE color bars when this button is pressed.
SCAN button
UNDER SCAN: At this setting, signals in the video
signal standard area can be viewed.
OVER SCAN:This setting provides overscanning of
around 8% so that about 85% of the
video signal standard area is
displayed.
Overscanning displays are used by consumer products
although their scanning ratio differs from product to
product.
6
Volume controls
The volume level is altered by pressing the up (W) and
down (X) buttons.
8
Tally lamp
The lamp (red) lights due to remote control operation.
See “REMOTE specifications” (page 10) for details.
Parts and their functions (front panel)
POWER
INPUT SCAN BLUE
MENU/
EXIT
ENTER
MENU VOLUME
1 2
3
4 5 6
7
8
Introduction
The BT-LS1400 commercial-use LCD video monitor features a 14 v-type LCD screen, a slim and lightweight design, and a
wide angle of view. Its connectors support not only standard NTSC signal input but S-Video, 480i , P component signal input
and SD SDI (optional) input as well.
∫ Wide angle of view
By using an LCD screen with a wide angle of view,
exceptional image visibility is assured across wide angle
ranges in both the top-bottom and left-right directions.
∫ Color temperature, gamma correction
The color temperature complies with the D65 and D93
standards while gamma correction is set to the 2.2 curve.
∫ Mode settings
Users can choose between three modes: the image pro-
duction mode (BROADCAST), the general user image-
receiving mode (GENERAL), and the user setting mode
(USER).
∫ Functions
This monitor is equipped with a blue-only function for
adjusting the hue, and an underscanning function for dis-
playing the whole screen.
∫ REMOTE connector
This enables parallel remote input control which in turn
makes it possible to select functions.
7
Speaker