Filter
Top Products
39
Basic Operation
38
Select the item pressing the F or G
buttons on the remote control unit or
the projector.
Press the I or H buttons, to adjust
the alternative items. For the
numerically adjustable items, press
the ENTER button to display an
individual screen, and press the I
or H buttons to adjust the setting.
Some items can be adjusted
pressing the F or G buttons.
Adjusting the position
When the input signal is RGB, first
press the AUTO SETUP button to
initiate automatic positioning.
If the optimum setting is not
obtained when AUTO SETUP is
carried out, adjust by the following
procedure.
POSITION
POSITION
DOT CLOCK
CLOCK PHASE
KEYSTONE
OSD POSITION
RESIZING
AUTO SETUP
FRAME LOCK
STANDARD
H: 128 V: 32
H: 0 V: 0
32
16
OFF
OFF
ON
ON
TOP LEFT
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When an RGB/DVI signal is being
input
“POSITION”, “DOT CLOCK” and
“CLOCK PHASE” are not displayed
when a DVI signal is being input.
POSITION
POSITION
KEYSTONE
OSD POSITION
ASPECT
RESIZING
AUTO SETUP
STANDARD
H: 32 V: 16
H: 0 V: 0
OFF ON
TOP LEFT
AUTO
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When an S-VIDEO/VIDEO signal is
being input
POSITION
POSITION
KEYSTONE
OSD POSITION
ASPECT
RESIZING
AUTO SETUP
STANDARD
H: 32 V: 32
H: 0 V: 0
OFF ON
TOP LEFT
4:3
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When a YPBPR signal is being input.
POSITION
KEYSTONE
OSD POSITION
AUTO SETUP
STANDARD
H: 0 V: 0
TOP LEFT
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
When the NETWORK/SD CARD is
selected (PT-L780NTU only)
WHITE BALANCE R/G/B
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised. Press the I button to
make the selected color lighter.
Press the H button to make the
selected color stronger.
Projecting sRGB-
compatible pictures
sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictures to be
reproduced more faithfully, make
the following settings.
#Press the
FF
or
GG
button to
select “PICTURE MODE”, and
then use the
II
or
HH
button to
select “NATURAL”.
$Press the
FF
or
GG
button to
select “COLOR TEMP.”, and
then use the
II
or
HH
button to
select “STANDARD”.
%Select the STANDARD from the
menu screen by pressing the
FF
or
GG
buttons and then press
the ENTER button.
&Select the LAMP POWER item
in the OPTION menu by
pressing the
FF
or
GG
buttons
and set to “HIGH” by pressing
the
II
or
HH
buttons. (pages 44
and 45)
NOTE:
BsRGB is only enabled when RGB
signals are being input .