Panasonic PT-LB10NTU Projector User Manual


 
SIGNAL MODE
(RGB/YPB
PR/NETWORK only)
This displays the type of signal
which is currently being projected.
Refer to the list on page 60 for
details on each type of signal.
sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictres to be reproduced
more faithfully, make the following
settings.
#Press the
FF
or
GG
button to
select “PICTURE MODE”, and
then press the
II
or
HH
button
to select “NATURAL”.
$Press the STD (standard)
button on the remote control
unit.
%Press the
FF
or
GG
button to
select “COLOR TEMP.”, and
then press the
II
or
HH
button
to select “STANDARD”.
ENGLISH-39
Adjustments and settings
38-ENGLISH
CONTRAST
This adjusts the contrast of the
picture. (Adjust the BRIGHT
setting first if required before
adjusting the CONTRAST setting.)
The picture is bright: I button
The picture is dark: H button
BRIGHT
This adjusts the darker areas (black
areas) in the picture.
Black areas are too light: I button
Dark areas are too solid: H button
COLOR
(S-VIDEO/VIDEO/YPBP
R only)
The color is too deep: I button
The color is too pale: H button
TINT
(NTSC/NTSC 4.43/YPBPR only)
This adjusts the flesh tones in the
picture.
The flesh tones are greenish:
I button
The flesh tones are reddish:
H button
SHARPNESS
To soften the picture details:
I button
To sharpen the picture details:
H button
COLOR TEMP.
This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
White balance R/G/B
(W-BAL R/G/B)
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colourised.
To make the selected color lighter
:
I button
To make the selected color stronger
:
H button
AI
ON
The lamp is controlled according to
the input signals to project images
with the best quality.
OFF
AI is disabled.
COLOR TEMP. STANDARD
[
HIGH
[
LOW
STILL MODE
(S-VIDEO/VIDEO only)
To reduce flickering of still images
(vertical flicker), set STILL MODE
to ON.
NOTE:
BAI is disabled when LAMP
POWER is set to LOW.
(Refer to page 45.)
Projecting sRGB-
compatible pictures
This should normally be set to
AUTO. If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
TV-SYSTEM AUTO
[
NTSC
[
NTSC4.43
[
PAL
[
PAL-M
[
PAL-N
[
SECAM
TV-SYSTEM
(S-VIDEO/VIDEO only)
NOTE:
BWhen set to AUTO, the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.
NOTE:
BSet to OFF when playing
back moving images.
NOTE:
BsRGB is only enabled when
RGB signals are being input
(when LAMP POWER is set
to HIGH and AI is set to
OFF).