Filter
Top Products
Basic Operation
Remote control operation
ENGLISH - 25
J Adjustment example
Project a commercial test signal for picture
adjustment on the screen and press the
WAVEFORM button.
Q Adjusting with luminance options
1. Press the ENTER button several times to display
FULL SCAN(Y)/SINGLE LINE SCAN(Y).
In SINGLE LINE SCAN mode, select the required
adjusting point by pressing F G.
2. Press the PICTURE ADJUSTMENT button and
display the BRIGHTNESS by pressing
F G.
When ADVANCED MENU is displayed, press the
button again to switch to the PICTURE menu.
3. Adjust by pressing I H.
Adjust the bottom line of the waveform to 0 % (0 or
7.5 IRE).
Setting range: -32 to +32
4. Press F G to display the CONTRAST.
5. Adjust by pressing I H.
Adjust the up line of the waveform to 100 %
(100 IRE).
Setting range: -64 to +64
Q Adjusting with RGB options
1. Press the ENTER button several times to display
the required R/G/B waveform option.
In SINGLE LINE SCAN mode, select the required
adjusting point by pressing F G.
2. Press the PICTURE ADJUSTMENT button and
display the BRIGHTNESS R/BRIGHTNESS G/
BRIGHTNESS B by pressing
F G.
When PICTURE menu is displayed, press the button
again to switch to the ADVANCED MENU.
3. Adjust by pressing I H.
Adjust the bottom line of the waveform to 0 % (0 or
7.5 IRE).
Setting range: -16 to +16
4. Press F G to display the CONTRAST R/
CONTRAST G/CONTRAST B.
5. Adjust by pressing I H.
Adjust the up line of the waveform to 100 %
(100 IRE).
Setting range: -32 to +32
100%
50%
0%
100%
5
0
%
0%
100%
5
0
%
0%
ENTER
ENTER
Image
displayable area
Adjust to 100%
Adjust to 0%
Monitor position
Image
displayable area
Adjust to 100%
Adjust to 0%
Monitor position
Signal level
Signal level
With COMPUTER (except 1080) or
HDMI (Expand)
FULL SCAN(Y)/SINGLE LINE SCAN(Y)
BRIGHTNESS
Adjust the bottom line of the
waveform to 0 % (0 or 7.5 IRE)
CONTRAST
Adjust the top line of the waveform to
100 % (100 IRE)
FULL SCAN(R)/SINGLE LINE SCAN(R)
BRIGHTNESS R
Adjust the bottom line of the
waveform to 0 % (0 or 7.5 IRE)
CONTRAST R
Adjust the top line of the waveform to
100 % (100 IRE)
FULL SCAN(G)/SINGLE LINE SCAN(G)
BRIGHTNESS G
Adjust the bottom line of the
waveform to 0 % (0 or 7.5 IRE)
CONTRAST G
Adjust the top line of the waveform to
100 % (100 IRE)
FULL SCAN(B)/SINGLE LINE SCAN(B)
BRIGHTNESS B
Adjust the bottom line of the
waveform to 0 % (0 or 7.5 IRE)
CONTRAST B
Adjust the top line of the waveform to
100 % (100 IRE)