Filter
Top Products
Chapter 1 Preparation — About your projector
24 - ENGLISH
About your projector
Remote control
1
3
2
4
5
7
6
8
9
10
11
12
19
13
14
15
16
17
18
20
21
Front Side Top
Bottom
1 Remote control indicator
Flashes if any button in the remote control is pressed.
2 Power standby <v> button
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
3 Power on <b> button
Starts projection when the <MAIN POWER> switch on the
projector is set to <ON> when the power is switched off
(standby mode).
4 Input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>,
<HDMI>, <SDI 1/2>) buttons
Switches the input signal to project. (x page 62)
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen. (x page 65)
6 <ON SCREEN> button
Switches on (display)/off (hide) the on-screen display function.
(x page 61)
7 <TEST> button
Displays the test pattern. (x page 63)
8 Number (<0> - <9>) buttons
Used when the system uses multiple projectors.
Used to input ID numbers or passwords.
9 <STATUS> button
Displays the projector information.
10 <LIGHT> button
Pressing this button lights up the remote control buttons. The
lights will go off when the remote control operation goes idle for
10 seconds.
11 <AUTO SETUP> button
Automatically adjusts the image display position while projecting
the image.
[PROGRESS] is displayed on the screen while adjusting
automatically. (x page 62)
12 <SHUTTER> button
Used to temporarily turn off the image. (x page 61)
13 <ASPECT> button
Switches the aspect ratio of the image. (x page 63)
14 Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (x page 56)
15 <FUNC> button
Assigns a frequently used operation as a shortcut button.
(x page 63)
16 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 66)
17 <ID SET> button
Sets the ID number of the remote control to use for a system
using multiple projectors. (x page 28)
18 <ID ALL> button
Used to simultaneously control all the projectors with one
remote control for a system using multiple projectors.
(x page 28)
19 <LOCK> button
Used to prevent unintended operation by careless pressing of
the buttons and prevent draining the remote control batteries.
20 Remote control signal transmitter
21 Remote control wired terminal
Connects to the projector with a cable. (x page 29)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.