Filter
Top Products
Setting
66
- ENGLISH
Settings
HDMI setup
This function is only used for HDMI input source.
Press ▲▼ to select [HDMI setup].1 )
Press ► or the <ENTER> button.2 )
The names for the output setting of Digital R/G/
z
B vary from equipment to equipment.
HDMI signal level
J
64-940
When the output of Digital R/G/B
equipment is set to Standard.
0-1023
When the output of Digital R/G/B
equipment is set to Enhanced.
Sound
J
HDMI
When Digital input source is input,
Sound is set to HDMI.
AUDIO 1
When DVI input source is changed
to HDMI input source, Sound is set
to
AUDIO 1
.
Note
For details, refer to the operating instructions of your
z
Digital R/G/B equipment.
DVI signal level
This function is only used for DVI-D input source.
Press ▲▼ to select [DVI signal level] 1 )
and then press the <ENTER> button.
Press ▲▼ to switch the item.2 )
16-235
When you want to enhance
the weaken signal.
0-255:PC
When in normal condition.
Lamp power
This function allows you to change brightness of the
screen.
Press ▲▼ to select [Lamp power] and 1 )
then press the <ENTER> button .
Press ▲▼ to select one among the 2 )
modes as below.
Auto
Brightness according to the input
signal.
Normal
The lamp power output is
maximum.
Eco1
The lamp power output is 80%
of the Normal mode.
Eco2
The lamp power output is 30% -
80% of the Normal mode.
Fan control
Press ▲▼ to select [Fan control] and 1 )
then Press <ENTER> button.
Press ▲▼ to select one among 2 )
options as below.
Choose the running speed of cooling fans from
z
the following options according to the ground
elevation under which you use the projector.
Off
Normal speed.*
1
On 1
Faster than [Off] mode.*
2
On 2
Faster than [On 1] mode.*
3
Set this function to [Off] when using the projector *1 :
in non-high altitude environment.
Select [On 1] when using the projector in high *2 :
altitudes (about 1 000 ~ 2 000 meters or more
above the sea level) where the fans have less
cooling effect.
Select [On 2] when using the projector in higher *3 :
altitudes (about 2 000 ~ 2 800 meters or more
above the sea level) where the fans have lesser
cooling effect.
Note
Failure to set the running speed of cooling fans
z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].
z